Differences

This shows you the differences between two versions of the page.

--- attenuator [2024/02/06 15:50] – ei3jdb
+++ attenuator [2024/02/06 16:16] (current) – ei3jdb
@@ Line 53: / Line 53: @@
 Here is my ugly soldering:-
+{{ :attenuator:soldering.jpg?400 |}}
+ * R1 is the large resistor labelled "Anaren"
+ * R2 is the pair of pale blue resistors
+ * R3 is the pair of black resistors numbered 100 0
+The black feeder is connected to the port on the left of the diagram; the copper-coloured feeder is connected to the port on the right of the diagram.  The black resistors are 1206 form factor so they're about 6.5mm and about 3mm wide.
+Even though the soldering is ugly the wires are quite short which, as you will see below, gives good performance up to 500MHz or so.
 ==Testing==
-Test that both the inputs produce the expected SWR measurements and impedance values (my NanoVNA said 49.something ohms and a few pF of capacitance in the 70cm band.) Also test that shorting out one port does not change the impedance values of the other by very much.
+Test that both the inputs produce the expected SWR measurements and impedance values (my NanoVNA said 49.something ohms and a few 100s of pF of capacitance in the 70cm band.) Also test that shorting out one port does not change the impedance values of the other by very much.
+{{ :attenuator:testing.jpg?400 |}}
 If these tests pass, you have an attenuator.