dwd-wefax
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
dwd-wefax [2022/02/24 17:08] – [DWD (Deutscher Wetterdienst) Weather Fax - 24th Feb 2022] mm3iig | dwd-wefax [2022/02/24 17:13] – mm3iig | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== DWD (Deutscher Wetterdienst) Weather Fax - 24th Feb 2022 ====== | ====== DWD (Deutscher Wetterdienst) Weather Fax - 24th Feb 2022 ====== | ||
- | The following images are a collection of images decoded from the DWD station DDK3 Hamburg (7880 kHz centre frequency) on the 24th February 2022. Below this are some notes on software/ | + | The following images are a collection of images decoded from the DWD station DDK3 Hamburg (7880 kHz centre frequency) on the 24th February 2022. Before the images |
Captures by Mark 2M0IIG, QTH Edinburgh | Captures by Mark 2M0IIG, QTH Edinburgh | ||
Line 8: | Line 8: | ||
A full list of worldwide Wefax services provided by the US National Weather Service can be found here: https:// | A full list of worldwide Wefax services provided by the US National Weather Service can be found here: https:// | ||
+ | |||
+ | ===== Hardware/ | ||
+ | |||
+ | ==== Hardware ==== | ||
+ | |||
+ | Radio used was an [[https:// | ||
+ | |||
+ | The SDR is connected to a standard Windows 10 laptop (HP Pavillion). | ||
+ | |||
+ | ==== Software ==== | ||
+ | |||
+ | I am using [[https:// | ||
+ | |||
+ | I have adjusted the settings for the Wefax decoder in FLDigi to make sure that it auto-starts, | ||
+ | |||
+ | Also note that when tuning in USB mode you should tune 1.9 kHz lower than the specified frequency to obtain the entire signal in the passband. For DDK3 this means a frequency in SDR++ of 7878.1 kHz. | ||
===== Decoded Charts ===== | ===== Decoded Charts ===== | ||
Line 78: | Line 94: | ||
{{: | {{: | ||
- | |||
- | ===== Hardware/ | ||
- | |||
- | ==== Hardware ==== | ||
- | |||
- | Radio used was an [[https:// | ||
- | |||
- | The SDR is connected to a standard Windows 10 laptop (HP Pavillion). | ||
- | |||
- | ==== Software ==== | ||
- | |||
- | I am using [[https:// | ||
- | |||
- | I have adjusted the settings for the Wefax decoder in FLDigi to make sure that it auto-starts, | ||
- | |||
- | Also note that when tuning in USB mode you should tune 1.9 kHz lower than the specified frequency to obtain the entire signal in the passband. For DDK3 this means a frequency in SDR++ of 7878.1 kHz. |
dwd-wefax.txt · Last modified: 2022/06/01 19:51 by mm3iig