ftm300gpsmod
Differences
This shows you the differences between two versions of the page.
Next revision | Previous revisionNext revisionBoth sides next revision | ||
ftm300gpsmod [2022/04/12 22:04] – created ei5iyb | ftm300gpsmod [2022/04/13 10:40] – [Programming the GPS Module in U-Center] m0smu | ||
---|---|---|---|
Line 30: | Line 30: | ||
===== Method ===== | ===== Method ===== | ||
+ | |||
+ | ==== Programming the GPS Module in U-Center ==== | ||
+ | |||
+ | - Install [[https:// | ||
+ | - Open U-Center | ||
+ | - Connect the GPS module via USB and use Device Manager to identify the COM port | ||
+ | - Set the COM port in u-center as per device manager and click connect | ||
+ | - {{:: | ||
+ | - Wait for GPS to lock on (you will see a position appear in u-center) | ||
+ | - {{:: | ||
+ | - Open the View menu and select Configuration View | ||
+ | - {{:: | ||
+ | - Select GNSS in the left hand pane and ensure only GPS, SBAS and QZSS are enabled. Ensure Galileo and GLONASS are DISABLED. Make sure you click '' | ||
+ | - {{:: | ||
+ | - Select NEMA in the left hand pane and set Main Talker Id to '' | ||
+ | - {{:: | ||
+ | - Finally we need to save the configuration to the module. | ||
+ | - Select CFG in the left hand pane, Hold '' | ||
+ | - {{:: | ||
+ | - Test the configuration by disconnecting and powering down the module and reconnecting. | ||
+ | - If successful, open the View menu and Select '' | ||
+ | - You should only see messages that start '' | ||
+ | - {{:: | ||
+ | |||
==== TL;DR ==== | ==== TL;DR ==== | ||
Yaesu FTM-300 requires higher logic levels than BN-220 can provide. MAX3232 is used to translate lower TTL logic levels to higher RS232 logic levels - [[https:// | Yaesu FTM-300 requires higher logic levels than BN-220 can provide. MAX3232 is used to translate lower TTL logic levels to higher RS232 logic levels - [[https:// | ||
ftm300gpsmod.txt · Last modified: 2022/04/13 10:49 by ei5iyb