Differences

This shows you the differences between two versions of the page.

--- packet:mmdvm-tnc [2024/04/03 17:23] – m0lte
+++ packet:mmdvm-tnc [2024/04/14 11:22] – [Building and flashing from source] m0lte
@@ Line 22: / Line 22: @@
 Burn Raspberry Pi OS Bullseye 32 bit Lite to a micro SD, boot it
-''sudo raspi-config'' → interfaces → serial port → serial shell disabled, serial port enabled
+''sudo raspi-config'' → interface options → serial port → serial shell disabled, serial port enabled
 Then:
@@ Line 32: / Line 32: @@
 # Fetch the flashing tool
-curl -OL https://www.bi7jta.org/files/MMDVM_Firmware/repeater_HAT/stm32flashV5
+curl -OLs https://www.bi7jta.org/files/MMDVM_Firmware/repeater_HAT/stm32flashV5
 chmod +x stm32flashV5
@@ Line 38: / Line 38: @@
 </code>
-===== Flashing from the web =====
+===== Building and flashing from source =====
-Unplug the board from the header
-Run the following:
-<code>
-curl -O https://mmdvm-tnc.s3.eu-west-2.amazonaws.com/mmdvm-f4-simplex.hex
-while ! sudo ./stm32flashV5 -v -w mmdvm-f4-simplex.hex -R -i 20,-21,21:-20,-21,21 /dev/ttyAMA0; do echo Again; done
-</code>
-Carefully but swiftly (!) plug the board into the header
-This is required because of some capacitor in the wrong charge state and there may be some workaround coming.
-===== Building and flashing from source (hard(ish) mode) =====
 <code>
@@ Line 76: / Line 60: @@
 while ! sudo ./stm32flashV5 -v -w bin/mmdvm_f4.hex -R -i 20,-21,21:-20,-21,21 /dev/ttyAMA0; do echo Again; done
 </code>
+Carefully but swiftly (!) plug the board into the header. If it fails, unplug the board for a while and leave it before trying again later. A minute or two should be fine.
+This is required because of some capacitor in the wrong charge state and there may be some workaround coming.
 ===== Testing notes =====
@@ Line 103: / Line 92: @@
 <code>
 sudo python3 kiss-ax25-ui-batch.py /dev/ttyAMA0 115200 A0AAA B0BBB 100 "Hello world" 100 1
+</code>
+This will listen:
+<code>
+sudo python3 kiss-listen.py /dev/ttyAMA0 115200
 </code>