packet:ninotnc
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
packet:ninotnc [2024/03/14 22:29] – [Auto mode switch] m0lte | packet:ninotnc [2024/04/01 16:43] – [Cheat sheet] m0lte | ||
---|---|---|---|
Line 57: | Line 57: | ||
===== Signals settings ===== | ===== Signals settings ===== | ||
+ | |||
+ | |||
+ | ==== Cheat sheet ==== | ||
+ | |||
+ | * Switch 1 is TX audio range selection - on/up is high level for louder transmitted audio, off/down is for quieter transmitted audio | ||
+ | * Switch 2 is RX audio sensitivity - on/up is low sensitivity for loud radios, off/down is high sensitivity for quiet radios | ||
+ | * Switch 3 is AC/DC coupling - normally should be off/down apart from specific radios | ||
+ | * Switch 4 is external carrier detect - normally should be off/down unless you need it for a specific purpose | ||
+ | |||
+ | ^ Radio ^ Signals ^ Notes ^ | ||
+ | | Yaesu FT-450D | ||
+ | | Tait TM8100 / 8200 | 1100 | Requires high level TX audio, else the transmitted audio is too quiet in the range of the pot.\\ Requires low level RX audio, else CRC is always lit. \\ Requires AC coupling to block the DC which is present on the TX audio pin. | | ||
==== Switch 1 - Transmit audio range selection - DATA/MIC ==== | ==== Switch 1 - Transmit audio range selection - DATA/MIC ==== | ||
packet/ninotnc.txt · Last modified: 2024/08/04 08:57 by g4wqg