packet:ninotnc
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
packet:ninotnc [2024/04/01 16:43] – [Cheat sheet] m0lte | packet:ninotnc [2024/04/01 17:42] – [Firmware] m0lte | ||
---|---|---|---|
Line 69: | Line 69: | ||
| Yaesu FT-450D | | Yaesu FT-450D | ||
| Tait TM8100 / 8200 | 1100 | Requires high level TX audio, else the transmitted audio is too quiet in the range of the pot.\\ Requires low level RX audio, else CRC is always lit. \\ Requires AC coupling to block the DC which is present on the TX audio pin. | | | Tait TM8100 / 8200 | 1100 | Requires high level TX audio, else the transmitted audio is too quiet in the range of the pot.\\ Requires low level RX audio, else CRC is always lit. \\ Requires AC coupling to block the DC which is present on the TX audio pin. | | ||
+ | | Tait T2010 | 1100 | | | ||
==== Switch 1 - Transmit audio range selection - DATA/MIC ==== | ==== Switch 1 - Transmit audio range selection - DATA/MIC ==== | ||
Line 329: | Line 330: | ||
{{: | {{: | ||
+ | ===== Firmware ===== | ||
+ | |||
+ | To upgrade the firmware, see https:// | ||
+ | |||
+ | TL;DR: | ||
+ | |||
+ | < | ||
+ | # save a headache | ||
+ | sudo systemctl disable linbpq | ||
+ | sudo reboot | ||
+ | |||
+ | sudo apt install -y python3 python3-pip python3-serial git | ||
+ | git clone https:// | ||
+ | cd flashtnc | ||
+ | python3 flashtnc.py N9600A-v3-35.hex / | ||
+ | </ |
packet/ninotnc.txt · Last modified: 2024/08/04 08:57 by g4wqg