packet:ninotnc
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
packet:ninotnc [2024/04/02 07:51] – [Cheat sheet] 2e0ijc | packet:ninotnc [2024/05/13 17:48] – [Cheat sheet] m0lte | ||
---|---|---|---|
Line 70: | Line 70: | ||
| Tait TM8100 / 8200 | 1100 | Requires high level TX audio, else the transmitted audio is too quiet in the range of the pot.\\ Requires low level RX audio, else CRC is always lit. \\ Requires AC coupling to block the DC which is present on the TX audio pin. | | | Tait TM8100 / 8200 | 1100 | Requires high level TX audio, else the transmitted audio is too quiet in the range of the pot.\\ Requires low level RX audio, else CRC is always lit. \\ Requires AC coupling to block the DC which is present on the TX audio pin. | | ||
| Tait T2010 | 1100 | | | | Tait T2010 | 1100 | | | ||
- | | Yaesu FTM-300D | 1100 | | | + | | Yaesu FTM-300D | 1100 | Tested up to Modes 0100 4800 GFSK IL2P+CRC | |
+ | | Kenwood TK-90 | 0100 | TX audio is pretty sensitive, works better in mic range. | ||
==== Switch 1 - Transmit audio range selection - DATA/MIC ==== | ==== Switch 1 - Transmit audio range selection - DATA/MIC ==== | ||
Line 277: | Line 278: | ||
</ | </ | ||
After creating said file, run '' | After creating said file, run '' | ||
+ | |||
+ | If this doesn' | ||
+ | |||
+ | '' | ||
+ | |||
+ | '' | ||
+ | |||
+ | If preferred, the same tool can be used to specify a serial number for the device. | ||
+ | |||
+ | '' | ||
+ | |||
+ | Then rerun the udevadm trigger command above. | ||
==== Auto mode switch ==== | ==== Auto mode switch ==== |
packet/ninotnc.txt · Last modified: 2024/09/21 18:13 by m0lte