Differences

This shows you the differences between two versions of the page.

--- packet:ninotnc [2024/04/01 17:44] – [Firmware] m0lte
+++ packet:ninotnc [2024/05/13 17:48] (current) – [Cheat sheet] m0lte
@@ Line 70: / Line 70: @@
 | Tait TM8100 / 8200 | 1100    | Requires high level TX audio, else the transmitted audio is too quiet in the range of the pot.\\ Requires low level RX audio, else CRC is always lit. \\ Requires AC coupling to block the DC which is present on the TX audio pin. |
 | Tait T2010 | 1100    |  |
+| Yaesu FTM-300D | 1100    | Tested up to Modes 0100 4800 GFSK IL2P+CRC |
+| Kenwood TK-90 | 0100 | TX audio is pretty sensitive, works better in mic range. |
 ==== Switch 1 - Transmit audio range selection - DATA/MIC ====
@@ Line 276: / Line 278: @@
 </file>
 After creating said file, run ''udevadm trigger'' for it to take effect without rebooting.
+If this doesn't work immediately, it may be the NinoTNC is not configured to expose its serial number. This can be enabled using the tool at https://github.com/g5dsg/2221aTool.
+''git clone https://github.com/g5dsg/2221aTool.git''
+''sudo python3 ./2221aTool.py enum-serial 1''
+If preferred, the same tool can be used to specify a serial number for the device.
+''sudo python3 ./2221aTool.py set-serial 0123456789''
+Then rerun the udevadm trigger command above.
 ==== Auto mode switch ====