radios:tait2xxx
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
radios:tait2xxx [2024/02/26 23:37] – [Diplomat UK Data Interface Board (DU5095)] 2e0hkd | radios:tait2xxx [2024/03/26 23:15] – mm0rfn | ||
---|---|---|---|
Line 147: | Line 147: | ||
A couple of T2010s from eBay turned up with this board fitted. It appears to be a slimmed down version of the T2000-A81 board, but the pinout remains the same. | A couple of T2010s from eBay turned up with this board fitted. It appears to be a slimmed down version of the T2000-A81 board, but the pinout remains the same. | ||
- | |||
- | With this board a NinoTNC Signals dip switch setting of 1100 was found to work (I'm not sure if the option board matters specifically for this setting). | ||
{{: | {{: | ||
Line 164: | Line 162: | ||
A couple of different issue numbers of this board has been seen, that seem lartgely the same with some minor differences in PCB layout. Iss 3 has been confirmed with the pinout below, and Iss 5 is also believed to be the same based on [[https:// | A couple of different issue numbers of this board has been seen, that seem lartgely the same with some minor differences in PCB layout. Iss 3 has been confirmed with the pinout below, and Iss 5 is also believed to be the same based on [[https:// | ||
+ | |||
+ | With this board a NinoTNC Signals dip switch setting of 1100 was found to work (I'm not sure if the option board matters specifically for this setting). | ||
{{: | {{: | ||
+ | |||
+ | {{: | ||
{{: | {{: | ||
Line 215: | Line 217: | ||
| 5 | Gnd | | | 5 | Gnd | | ||
| 6 | Rx Data (Input) | | | 6 | Rx Data (Input) | | ||
+ | |||
+ | |||
+ | ====== Internal Adjustment Controls ====== | ||
+ | |||
+ | You may not need to mess with these, but you can use internal pots to fine-tune frequency, deviation, CTCSS deviation, and output power (and probably a few other things as well based on the diagram). | ||
+ | |||
+ | When programming the radio, you can set a channel to high or low power, and the power pot will affect both these settings. This can be useful if you are looking for a specific power output. There is a hole in the metal cover through which you can inset a flat head screwdriver to adjust. It is very sensitive, so only give it a little movement. | ||
+ | |||
+ | {{: | ||
+ | |||
+ | {{: | ||
+ | |||
====== Programming ====== | ====== Programming ====== | ||
Line 260: | Line 274: | ||
{{: | {{: | ||
+ | {{tag> |
radios/tait2xxx.txt · Last modified: 2024/08/22 08:53 by g4wqg