Differences

This shows you the differences between two versions of the page.

--- radios:tait_tm8200 [2023/05/17 20:59] – 2e0sip
+++ radios:tait_tm8200 [2023/06/06 21:55] – [Programming] 2e0sip
@@ Line 78: / Line 78: @@
 {{:radios:tait_tm8100_aux_connector.jpg?direct&600|}}
-====== Programming ======
+====== Programming Cable ======
 ===== Programming  Cable =====
@@ Line 95: / Line 95: @@
   * If the radio doesn't seem to respond to the software it might be configured to use a keypad mic, or use the mic port for data. Turn the radio off, trigger the read or write within the software and immediately turn the radio on. It should then beep and reboot into programming mode. It can take a couple of attempts to get the timing right, and you will have to do it each time the radio is read or written to.
   * If you've got a radio that's already programmed, it's best to start with a fresh configuration rather than reading from the radio and making changes, to avoid buried settings causing problems later down the line. The programming application will start with a fresh factory default config each time its opened.
-  * To upgrade the radio firmware see [[radios:tait_tmxxx_firmware|Tait TM8XXX - Firmware upgrades]]
+  * To upgrade the radio firmware see [[radios:tait_tmxxx_firmware|Tait TM8XXX Firmware upgrades]]
+  * For troubleshooting and repairs see [[radios:tait_tmxxx_repairs|Tait TM8XXX Repairs]]
 ===== Control Head Notes =====