member-projects:tait-cross-band-repeater
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| member-projects:tait-cross-band-repeater [2025/08/09 21:35] – [Cable] m0lte | member-projects:tait-cross-band-repeater [2025/08/09 21:35] (current) – [Cable] m0lte | ||
|---|---|---|---|
| Line 37: | Line 37: | ||
| In the official cable there is a board. Most of it can be ignored, however both the audio lines are connected to ground via 600 ohms, and have 4.7uF inline. During the event I did not have this cable, and I found I was transmitting distored audio - I suspect omitting the resistors and maybe the DC blocking capacitors was responsible for this. So I recommend adding at least the resistors. | In the official cable there is a board. Most of it can be ignored, however both the audio lines are connected to ground via 600 ohms, and have 4.7uF inline. During the event I did not have this cable, and I found I was transmitting distored audio - I suspect omitting the resistors and maybe the DC blocking capacitors was responsible for this. So I recommend adding at least the resistors. | ||
| - | {{: | + | Board- important bits highlighted. |
| + | |||
| + | {{: | ||
| ===== Settings ===== | ===== Settings ===== | ||
member-projects/tait-cross-band-repeater.1754775326.txt.gz · Last modified: by m0lte