packet:9k6-rig-support
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
packet:9k6-rig-support [2024/01/14 23:40] – [The measurement setup] g7bcs | packet:9k6-rig-support [2024/01/14 23:45] (current) – [Receive delay and setting time] g7bcs | ||
---|---|---|---|
Line 45: | Line 45: | ||
===== The Rigs ===== | ===== The Rigs ===== | ||
- | The three rigs I tested were the Tait TM8200, an Icom IC-E208 and a Yaesu FT-7800. The latter two had both failed to perform at 9k6. The former is well proven to work flawlessly. I had previously also tried a Yaesu FT-817 on 9k6 packet, unsuccessfully, | + | The three rigs I tested were the Tait TM8200, an Icom IC-E208 and a Yaesu FT-7800. The latter two had both failed to perform at 9k6. The former is well proven to work flawlessly. I had previously also tried a Yaesu FT-817 on 9k6 packet, unsuccessfully, |
===== The Measurements ===== | ===== The Measurements ===== | ||
Line 102: | Line 102: | ||
The top trace shows PTT being released at the end of a transmission (the RX frequency already has a modulated signal present). Bottom trace shows the demodulated output arriving from the rig as it recovers. | The top trace shows PTT being released at the end of a transmission (the RX frequency already has a modulated signal present). Bottom trace shows the demodulated output arriving from the rig as it recovers. | ||
+ | |||
{{: | {{: | ||
packet/9k6-rig-support.1705275617.txt.gz · Last modified: 2024/01/14 23:40 by g7bcs