Differences

This shows you the differences between two versions of the page.

--- packet:cables [2023/04/10 16:03] – m0lte
+++ packet:cables [2024/05/02 20:21] (current) – m0lte
@@ Line 25: / Line 25: @@
 Below is the excerpt from Yaesu-817ND Manual
-{{ :817nd_packet.png?direct |}}
+{{:817nd_packet.png?600|}}
+The cable:
+{{:packet:yaesu_to_nino_tnc.jpg?400|}}
+For my cables, I used PS/2 to PS/2 cables cut in half and connected as below to 9pin subD male. PS/2 to PS/2 cables are commonly available from the usual online outlets.
 ==== Understanding Tx and Rx operation ====
@@ Line 36: / Line 42: @@
 ==== Noise ====
-If you get noise on transmit, see [[packet:ft-450d|this page]] for info about audio isolation.
+If you get noise on transmit, see [[radios:ft-450d|this page]] for info about audio isolation.
 ===== Yaesu 10 pin mini DIN =====
@@ Line 55: / Line 61: @@
 Remainder of pins omitted because they are not relevant to packet.
-For my cables, I used PS2 to PS2 cables cut in half and connected as below to 9pin subD male
-{{:packet:ft817.jpg?400|}}
 ===== Kenwood K plug / K1 connector / Baofeng / Wouxun etc =====
@@ Line 92: / Line 96: @@
 See [[packet:ic7300]]
+===== Xiegu G90 =====
+A suitable mini DIN 8 pin connector is available from [[https://shop.technofix.uk/breakout-cable-8-pin-mini-din-for-yaesu-band-data-cat-linear-tuner-etc|TechnoFix]]. It should be wired up according to the diagram below. Signals DIP switches on the NinoTNC should be set to 1010. If using the latest G90 Firmware, ensure that the mode is set to U-D.
+{{:packet:g90_ninotnc_cable_wiring.png?400 |}}