Differences

This shows you the differences between two versions of the page.

--- waoarc25:kit-build-guide [2025/07/28 14:53] – [Connectors] gi3jmc
+++ waoarc25:kit-build-guide [2025/07/30 10:54] (current) – [Transistor] gi3jmc
@@ Line 64: / Line 64: @@
 ==== Transistor ====
 <WRAP left round box half>
-Install the transistor.\\
+Install the transistor. Make certain the direction installed matches the silkscreen on the board (Flat surface towards edge).
-Make certain the direction installed matches the silkscreen on the board\\
-(Flat surface towards edge).
+The pads are quite small and really close together - make sure you don't bridge them together when soldering.
 ^Reference ^Component ^
@@ Line 132: / Line 132: @@
 {{ :waoarc25:wsprkit-40pin-socket.png?direct&600|}}
 </WRAP>//
 <WRAP left round box half>
 |{{ :waoarc25:wsprkit-sma-2.png?direct&275|}}|{{ :waoarc25:wsprkit-sma-1.png?direct&275|}}|
@@ Line 138: / Line 139: @@
 <WRAP left round box half>
 {{ :waoarc25:wsprkit-complete.png?direct&600|}}
+</WRAP>//
+----
+==== Filter Installation ====
+<WRAP left round box half>
+When connecting your filter, (build instructions at [[https://qrp-labs.com/images/lpfkit/assembly_A4.pdf]]) you should ensure that is inserted in the correct orientation.  The filter has 'IN' and 'OUT' text on the ends, and you need the 'OUT' nearest the SMA connector.
+</WRAP>
+<WRAP left round box half>
+{{:waoarc25:wsprkit-filter-installed.jpg?direct|}}
 </WRAP>