packet:linbpq_pi_installation
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| packet:linbpq_pi_installation [2023/10/01 22:20] – [Installing LinBPQ on a Raspberry Pi] m0lte | packet:linbpq_pi_installation [2026/08/07 21:21] (current) – Mort upgrade: escape literal asterisks so the quoted string renders verbatim 0.0.0.0 | ||
|---|---|---|---|
| Line 84: | Line 84: | ||
| 2. Run the command **sudo nano bpq32.cfg** to open the configuration file\\ | 2. Run the command **sudo nano bpq32.cfg** to open the configuration file\\ | ||
| 3. Spend a few minutes looking over this file. The tool we used has added a load of comments telling you what everything does.\\ | 3. Spend a few minutes looking over this file. The tool we used has added a load of comments telling you what everything does.\\ | ||
| - | 4. Navigate to the section that starts *******Port 1*******\\ | + | 4. Navigate to the section that starts |
| 5. Change the COMPORT and SPEED to the correct values - in the case of a NinoTNC you would change: | 5. Change the COMPORT and SPEED to the correct values - in the case of a NinoTNC you would change: | ||
| \\ | \\ | ||
packet/linbpq_pi_installation.txt · Last modified: by 0.0.0.0