Differences

This shows you the differences between two versions of the page.

--- packet:cables [2024/03/30 15:09] – m0lte
+++ packet:cables [2025/12/20 21:05] (current) – m0lte
@@ Line 11: / Line 11: @@
 All you need to do then is work out (with a multimeter) which pin corresponds to each wire, and tack them to the pins on a 9 pin D shell plug as follows:
-^  Yaesu pin  ^ TNC Connection                ^  DB9 TNC pin    ^
+^  Yaesu pin  ^ TNC Connection            ^  DB9 TNC pin    ^
-|  1          | Transmit audio            |  1 Receive audio             |
+|  1          | Audio to be transmitted   |  1 Transmit audio (TXA)    |
 |  2          | Ground                    |  6 Ground             |
 |  3          | PTT                       |  3 PTT            |
-|  4          | Receive audio (9600 baud) |  5 (option)     |
+|  4          | Receive audio (9600 baud) |  5 Receive audio  |
-|  5          | Receive audio (1200 baud) |  5 (option)     |
+|  5          | Receive audio (1200 baud) |  5 Receive audio  |
 |  6          | Squelch                   |  Not connected  |
-Pick pin 4 if you'll be using 9600 baud, or pin 5 if you're using 1200 baud. You might be able to use pin 4 for 1200 baud as well.
+Radio's socket:
+{{:packet:yaesu-6-pin-mini-din-socket.png?200|}}
+Note: this is the BACK / SOLDER side of the PLUG:
+{{:kantronicstncwiring.png|}}
+Pick pin 4 if you'll be using 9600 baud, or pin 5 if you're using 1200 baud. You should be able to use pin 4 for 1200 baud as well.
 This is verified to work with FT-450D and FT-1500m, and likely very many other Yaesu radios too. This also appears to be the same for the Icom IC-7000.
@@ Line 42: / Line 51: @@
 ==== Noise ====
-If you get noise on transmit, see [[packet:ft-450d|this page]] for info about audio isolation.
+If you get noise on transmit, see [[radios:ft-450d|this page]] for info about audio isolation.
 ===== Yaesu 10 pin mini DIN =====
@@ Line 103: / Line 112: @@
 {{:packet:g90_ninotnc_cable_wiring.png?400 |}}
+===== Icom 746 HF Packet =====
+This pinout works only for HF. Plugs are shows from the "back" meaning from the soldering side.
+VHF PTT is triggered by ACC(2) socket.
+This pinout is for ACC(1) socket.
+{{:packet:din_8_to_nino_tnc.png?400|}}
+===== Icom IC9700 =====
+{{:packet:ic9700_to_ninotnc.jpg|}}