Differences

This shows you the differences between two versions of the page.

--- packet:linbpq_pi_installation [2023/10/01 22:19] – m0lte
+++ packet:linbpq_pi_installation [2026/08/07 21:21] (current) – Mort upgrade: escape literal asterisks so the quoted string renders verbatim 0.0.0.0
@@ Line 3: / Line 3: @@
 This is a document which describes the general case of installing and configuring LinBPQ on a Pi - this is probably not the instructions to establish a node specific to the OARC national packet project network.
-**NB this process has now been replaced since one of our members has kindly established an apt repo containing a build of LinBPQ. See [[packet:linbpq-apt-installation]]**
+**NB this process has now been superseded since one of our members has kindly established an apt repo containing a build of LinBPQ.\\
+See [[packet:linbpq-apt-installation]] for a guide.**
 ===== Assumptions =====
@@ Line 83: / Line 84: @@
 . Run the command **sudo nano bpq32.cfg** to open the configuration file\\
 . Spend a few minutes looking over this file. The tool we used has added a load of comments telling you what everything does.\\
-. Navigate to the section that starts *******Port 1*******\\
+. Navigate to the section that starts %%*******Port 1*******%%\\
 . Change the COMPORT and SPEED to the correct values - in the case of a NinoTNC you would change:
 \\